Remove the access panel and find the furnace pilot light assembly inside. Locate the reset switch and turn the switch to the OFF position. Wait 5-10 minutes to allow any natural gas in the area to dissipate so it will not ignite once the pilot light is back on.
How do you light a Williams?
How do you light a Williams wall furnace?
Have a match or long lighter available to light the pilot.Find the valve located in the heater and turn it to “Pilot”.Press inward on the valve. You should hear a hissing sound coming from the valve.Release the valve and light your match.Release the valve after one minute.
How do you turn on a pilot light?
Turn the gas regulator valve to the “pilot” position. If the water heater has a manual “ignite” button, press that to light the pilot. If it doesn’t have the button, or the button fails, press the regulator valve and hold a grill lighter or long match to the pilot light valve until the pilot ignites.
Why does my Williams wall heater keep turning off?
Blocked vents
Lack of air can cause the heaters to shut off of their own accord. If there is not a sufficient amount of air provided to the heater, the exchanger in the set won’t be able to give off heat as a transfer. Take a look at your supply vents and ensure that the area is not blocked.
Where is the reset button on a Williams wall heater?
3) Press/hold RED reset button (upper top left side of heater assembly; two wires were connected to it) for about 2 seconds. It immediately fired up.
Why is my pilot light not staying lit on my furnace?
If your pilot light won’t stay alight, it might be the thermocouple. Sometimes dust buildup collects on the thermocouple and blocks the sensor. Try cleaning the thermocouple and then relighting the pilot light. If it continues to go out, the thermocouple might need to be replaced.
Why would a furnace pilot light go out?
A faulty, misaligned, dirty, or damaged thermocouple is often the culprit behind your pilot light going out. The thermocouple is an automatic safety shutoff device that prevents the gas valve from opening if the pilot light is out.
Should the pilot light always be on in a gas heater?
Should The Pilot Light Always Be On In A Gas Furnace? Yes, if the furnace is in operation, the pilot light will need to be on for it to be functional. However, some homeowners turn off their furnace’s pilot light in the warmer seasons when the gas furnaces aren’t in use.
Is it OK to turn off pilot light?
A little heat is produced when your pilot light is on so turning it off in summer can help reduce the heat inside your home. The less heat there is, the less you have to use your air conditioner needs to cool down the house. You can get savings and conserve energy if you turn off your pilot light.
How do you fix a pilot light on a gas heater?
How to Fix Your Pilot Light
Find your gas valve. You need to turn the valve to the off position for at least three minutes.Once you have had the valve at off for a few minutes, switch it over to pilot setting.You will need a match that is lit. Set the pilot valve to the on position.
How do I know if my pilot light is on?
If your pilot light is on, it should be easy to see – your eyes will be drawn to the little flame. If you don’t see a flame, your pilot light is out. If there is a flame, check the color. Pilot lights should always be blue.
Can you light your own pilot light?
Using a long lighter, bring the flame close to the pilot opening. This should ignite the pilot light. Once the pilot is lit, you can release the reset button. The pilot should stay lit at this point.
