If your washing machine is showing a F11 error on the display, the machine is most likely having a problem draining the water from the drum.
How do I clear the error code on my Whirlpool washer?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
What is a F11 error?
The F11 error means the keypad is shorted which is why the control panel has to be replace to fix it.
What does F dL mean on a Whirlpool washer?
The F/dL code indicates a door lock error on the machine. When the door fails to lock to allow the cycle to begin, it attempts to lock itself at least six times before the error appears on the digital display screen. When the door fails to lock, the machine won’t run at all.
What does f1 mean on a Whirlpool Duet washer?
The F01 error on this model washer means the relay for the drain pump motor on the main control board (CCU) has failed to activate or a communication error between the Central Control Unit (CCU) and the EEPROM onboard the CCU occurred.
How do I reset my Whirlpool washer without unplugging it?
Follow these steps to reset a Whirlpool washing machine: Make sure the power to the washer is turned on at the wall, but keep the Power button on the control off. Hold the Program button down while simultaneously pressing the Water Level button two times. When done correctly, the control panel lights should illuminate.
What does PE mean on Whirlpool washer?
PE. Of all the Whirlpool washing machine error codes, PE is one that may require a professional repair. This code usually indicates a problem with the pressure level sensor. This sensor monitors how much water is in the machine, also telling the control board if it’s been filled or emptied.
How do I fix the F11 code on my Kenmore washer?
Unplug or turn the circuit breaker off for 10-20 minutes. Reconnect the unit to the power source by turning the breaker back on or plugging the washer back in. Press the Pause/Cancel/Stop button twice to clear the display.
How dO I fix a dL error?
Make sure the cover is closed properly. Lift the cover and slowly lower it. Then click on Start / Pause. If the door snaps into place, the DL error will disappear and the drum will begin to rotate.
