To test if your thermal fuse has blown, touch the right side of your multimeter lead to the right side of the fuse, and repeat with the left multimeter lead. If the multimeter needle fails to move, this indicates the thermal fuse has blown.
Where is the thermal fuse on the Whirlpool Duet dryer?
Remove the back access panel on the dryer, and look for the exhaust duct near the bottom of the unit. The thermal fuse is either circular or oblong, often white plastic with black material in the center and two wire leads. The thermal fuse is mounted on the exhaust duct.
Will dryer start if thermal fuse is blown?
A blown thermal fuse often prevents an electric dryer from starting. You’ll find the thermal fuse on the blower housing. Unplug the dryer and check the thermal fuse for continuity. Replace the thermal fuse if the multimeter measures no continuity.
Can you bypass dryer thermal fuse?
The thermal fuse will look like a thin strip of white plastic with a wire coming out of each end. In order to bypass the thermal fuse, use electrical tape to tape the two ends together. The thermal fuse will then be bypassed. Turn the dryer on to a heat cycle for no more than 90 seconds.
How do you tell if a thermal fuse is blown without a multimeter?
Is It Possible to Test Thermal Fuse Without a Multimeter?
You can use an analog Ohmmeter or a digital one. Touch the terminal of your Ohmmeter to the thermal fuse and wait a few seconds for the reading to appear. You can use jumper wires to test whether a thermal fuse is faulty if you don’t have a multimeter.
How do I reset my thermal fuse?
Step 1: Locate the Fuse. Study the owner’s manual for the location of the thermal fuse. Step 2: Cut Power to the Dryer. Step 3: Disassemble as Needed. Step 4: Disconnect the Thermal Fuse. Step 5: Conduct a Continuity Test. Step 6: Purchase a Replacement. Step 7: Replace the Fuse. Step 8: Reassemble the Dryer and Test It.
Why is my Whirlpool Duet dryer not powering on?
One of the most common reasons for you Duet’s power to be disrupted is a blown breaker in your service panel. The service panel is often located in your garage, laundry room or utility room, and is built into the wall. Use the breaker labels to locate the breaker to which the washer or dryer is connected.
Why does my dryer keep blowing the thermal fuse?
A thermal fuse will blow when the temperature gets too high, not when it’s drawing too much current. When it blows, the dryer stops generating heat. It’s necessary to replace it before the dryer will run again.
