The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places. 1-at the circuit breaker, 2-at the plug outlet or on the end of the cord (110 volt models, or 3- on the pack located near the heater chamber.
How do you change the mode on a Viking hot tub?
The mode is changed by pressing the “Temp” button, then pressing the “Light” button. Standard Mode is programmed to maintain the desired temperature. Note that the last measured spa temperature displayed is current only when the pump has been running for at least 2 minutes.
What is standard mode on Viking hot tub?
The default mode is St. This means the spa will always maintain your desired temperature. Even if you are not in your filter cycle the pump will come on low speed and the heater will turn on if there is heat demand. EC or economy mode will allow the temperature top drop 20 degrees from your desired temperature.
Is there a reset button on hot tub?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
Where is high limit reset button on Hot Springs spa?
The hot tub high limit switch is sometimes triggered when you’re refilling your hot tub and can be reset by pressing the large red button on your spa pack.
How do you unlock a Viking Spa hot tub?
Viking Spas has provided three access points located in the bottom corner to assist in running the electrical conduit to the power system. Simply remove the plug to access the opening. valves are in the open or up position. with no water circulating in spa for long periods.
How do you fix the error code on a hot tub?
This error message is similar to the FLO error message. Like FLO issues, this can commonly be fixed by topping off your hot tub water level. DR or DRY will show up if there is little to no water travelling through your heater.
Why are my spa jets not working?
Hot tub jets that are not working can be caused by air leaks, clogged drain covers, low water levels, dirty filters, bad pumps, improper jet adjustment, closed valves, electrical problems, clogged pump impeller, and issues with the hot tub controls. These issues should be troubleshot carefully.
What does code SL mean on hot tub?
SL: Sleep –
Similar to EC mode, the spa will only heat during the filtration cycles of the spa. Sleep mode will only allow the spa to heat within 20 degrees of the set temperature.
How do you reset hot tub after power outage?
A GFCI is required in all spa installations. It is a micro-circuit breaker, much more sensitive to voltage fluctuations than a normal circuit breaker. If the GFCI has been tripped by a power surge or brownout, just pressing the “RESET” button, if there is one, will turn the circuit, and your hot tub, back on.
