Locate the large red button marked “Reset” at the center of your State water heater’s control circuit panel. Firmly press the “Reset” button to manually reset your water heater.
How do you reset the pilot light on a gas water heater?
Turn the knob to “Off,” and then wait five minutes for the gas to clear before you follow these steps:
Open the door/cover over the pilot light access. Use a flashlight or a headlamp to find the burner inside. Turn the gas knob to “Pilot,” press and hold it down. While still holding the gas down, light that pilot.
Can I relight the pilot light by myself?
If your pilot light goes out, your furnace will not be able to produce heat because its burners will not ignite. Often, homeowners can relight the pilot themselves.
Why does my water heater not stay lit?
Thermocouple Issues
If it senses that your water heater pilot light keeps going out, the thermocouple will shift off the gas supply to the heater. Over time, thermocouples can malfunction, accumulate dust buildup, or the device can get bent away from the pilot light’s flame.
Are state water heaters made by AO Smith?
State is one of the brands that was purchased by AO Smith and is a popular choice for many plumbing contractors. The State water heater almost identical to the AO Smith but there were more installed in the Kansas City area in the past 10 years.
How old is my state select water heater?
State water heaters have the manufacture date listed in the serial number. The first two digits are the year and the second two are the week of the year. This tank was manufactured on the 24th week of 2009.
Where is the anode rod on a state water heater?
The anode rod in your State water heater is located on top of your tank. When you are facing the front of your water heater, the sacrificial magnesium or aluminum anode is located at the back, between the cold and hot water connections.
What causes a pilot light to go out?
Improper Venting & Airflow
Sometimes a pilot light can go out as a result of some source of wind or air simply blowing it out. If this happens, there could be an issue with how your flue pipe is set up or how your system is venting.
What do I do if my pilot light won’t light?
You need to turn the valve to the off position for at least three minutes. Once you have had the valve at off for a few minutes, switch it over to pilot setting. You will need a match that is lit. Hold it to the pilot opening and push the reset button on your pilot control.
How much does it cost to relight a pilot light?
Most service providers will charge a standard fee per visit that typically covers the cost to relight a gas water heater. This service call price can range from $80 to $100.
