Press and hold the throttle trigger lockout (located on the side of the chainsaw, above the trigger) with your thumb, then move the master control (on the left of the rear of the chainsaw) down as far as it will go. This is the position you should start the chainsaw in the first time you use it each session.
Why will my new Stihl chainsaw not start?
If the engine doesn’t start on the first three or four pulls, the fuel and air mixture becomes fuel rich, and if you continue to pull the starter while the choke is closed, there is too much fuel to ignite and the engine floods. You can simply wait for the fuel to drain, but there is a faster way to clear the engine.
How do you start a stubborn chainsaw?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
How long to wait if chainsaw is flooded?
Many people wonder if a flooded chainsaw will fix itself? The answer is yes, but not always. By letting the chainsaw sit for about 20 minutes it will allow some of the fuel inside the engine to evaporate.
What CC is a Stihl 036?
The engine moves at speeds up to 13,500 rpm when in operation, and the idle speed is 2,500 rpm. The engine displacement is 3.75 cubic inches., and this refers to the total volume the pistons can move through the cylinder.
