To delete all previous settings: Using a paperclip, press and hold the PROGRAM BUTTON located at the side of the motor for approximately 12 seconds, during which the motor will jog 3 separate times. All remotes and limits will be erased (motor is now reset to factory mode).
How do you wake up a Somfy engine?
Step 1: Connect power With the motor installed in the shade, connect power to the motor (120V, 24V or 12V transformer or 12V battery wand). Sonesse 30 Wirefree: Press the motor head programming button to wake up the motor.
Why is my Somfy remote blinking red?
Once you plug-in the device and switch it on the myLink will blink red. Open the myLink app and press Start New System. Follow the prompts for setup as they appear on screen. The solid red LED light is an indicator that the myLink is in setup mode.
How do I use the Somfy reset tool?
Home > Somfy Systems > Wireless Systems > Accessories
Press down the red button on tool and light will illuminate. Hold down on button until the red light goes out. Motor is now reset. Once the motor limits have been erased using this tool, the motor travel limits will have to be re-programmed.
How do I reprogram my electric blind?
Press and hold the “Prog” button for one second and the blind will beep and shunt once. On the remote control press the ‘Down’ button, and the motor will shunt once again. You have successfully programmed the blind and remote.
How do I reset my Somfy mylink?
How do I reset the Link?
unplug the Link, the Link indicator light must be off.if the Link indicator light is still on:plug the Link back in while holding the button down for 8 seconds, then release the button.
How do I program Somfy Sonesse 30 RTS?
PRESS & HOLD both the MY/ STOP and DOWN buttons until the shade begins to move down, then release. Stop the shade at the desired lower limit, adjust by pressing the UP or DOWN buttons. PROGRAMMING BUTTON on the back of the control. The shade will jog and will now operate in user mode.
How do I reprogram my Somfy shades?
To do so, locate the programming button on the back of the remote control. Then using a small screwdriver, or paperclip, press and hold the button until the shade jogs. The programming is now complete, the remote may now be used to operate the shade in user mode.
How do I sync my Somfy remote?
Press and hold the programming button on the back of the remote for one jog and then let go. The remote will now operate the motorized window covering! Learn how to safely and effectively maintain batteries for Somfy’s WireFree motor range.
