To run a Spin Only cycle on a model that does not have this option on the cycle selector dial, perform the following:
Power the unit on.Press and hold the spin key for approximately 3 seconds. A chime will sound.Select the spin level, if desired.Press the Start/Pause button.
Why is my washing machine washing but not spinning?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
How do I reset the spin on my Samsung washer?
What you can do instead is power cycle it: Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again. This is the closest you can get to a “reset” of the washer.
How do you fix a washer that won’t spin?
Redistribute an off-balanced load of laundry. Level an off-kilter washer. Check the power source. Stop using an extension cord. Inspect the spin switch. Stick to high efficiency detergent with a front-load washer. Undo any kink in the hose. Track down a blockage in the drainage system.
How do I troubleshoot my Samsung washer?
Troubleshooting
Unplug the machine. Disconnect the hoses.Remove the detergent drawer by pressing the central locking button.Open the hatch of the drain filter at the bottom of the front panel.Empty the water and clean the filter.Put the washer on a side so that you can access the bottom.
Why is my Samsung washer not filling up with water?
The most common reason is a problem with the water supply, or a blocked or kinked water supply hose. In this situation, the washing machine will drain for 3 minutes and the power button will be inoperative. In this case, please clean the debris filter and mesh filter.
Why are my clothes too wet after the spin cycle?
Overloading can lead to an imbalance that reduces the washer’s spin speed, leaving clothes too wet after spin cycle completes. If the washer leaves clothes soaked after a large load, remove some items, redistribute others and run another rinse and spin cycle.
