I located the tech. data sheet for your model, it says F5 is lid switch lock latch problem.
What does E3 and F5 mean on Maytag washer?
The F5 E3 alert indicates there is issue with the lid lock. Do not force the lid open, as permanent damage could occur. Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid.
How do I fix the F5 on my Whirlpool washer?
Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid. If this is unsuccessful, reboot the machine by unplugging the washer and wait two minutes before plugging the machine back in.
How do you reset the F5 code on a Whirlpool washer?
When using hot water in a Whirlpool washer, you may encounter the “F5” error code on the appliance. To finish the laundry load, reset the washer, wash in cold water and then fix the error to use hot water again.
What does F5 mean on a Maytag oven?
F5. Keypad Cancel Upper. This oven error code is seen on electric ranges and indicates that the electronic range control board is faulty. This Maytag error code displays when the cook mode and non-cook mode start simultaneously. Repair or replace the electronic range control board to fix this code.
How do I reset my Maytag washer?
To reset your Maytag Washer, first press Power/Cancel. Then, select a new cycle to run. Now, press Start/Pause, and your Maytag Washer should then reset.
What is F5 in Carrier AC?
CODE: F5. RESULT: No. E Indoor unit coil outlet temperature sensor or connector of sensor is defective.
What does F5 on boiler mean?
The F5 fault code on the display panel is a sign of an overheating boiler. It’s likely that your boiler is locked out, so it won’t start. In the case of an overheating fault, this ensures that no damage is done to internal components.
How do I reset the F5 on my Maytag washer?
F5 E4 or dr Error Code
Power unit down by turning off the circuit breaker or unplugging for one (1) minute.Power unit up by reconnecting power.Open and close the door.Restart a new cycle.Monitor the washer for one (1) minute to ensure the error code does not display again.
What does F5 mean on Whirlpool?
The F5 on most Whirlpool ranges will indicate that you have a problem with the oven door latch assembly or the oven door switch. Since you are seeing this error code when you are trying to set the self cleaning mode, this is likely the problem with your range. You could have a problem with the door switch.
How do I clear the error code on my Whirlpool washer?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
What does e1 F5 mean on a Whirlpool washer?
The F5E1 Error Code indicates that there may be an issue with the door switch/door lock. The door is unlocked during a cycle when it should be locked. Try resetting the washer/dryer by unplugging it from the outlet for at least 1 minute, and then plugging it back in.
How do I fix e5 error on my Whirlpool washer?
This alert indicates the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.
