Drain Hose Is Obstructed
An obstructed drain hose is one of the most common reasons a Maytag washer won’t drain. Both kinks and blockages can obstruct the hose, preventing proper draining. A kinked hose can be gently straightened to restore function.
Where is the drain filter on a Maytag Bravos washer?
Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter. Remove the drawer by releasing the tab on each side. With your finger, push down on tab on right side of drawer, and up on tab on left side of drawer.
How do I drain the water from my Maytag Bravos washing machine?
Turn off the Bravos’ water supply at the wall. Use pliers to turn the water supply hose connections at the back of washer counterclockwise to remove them from the appliance. Use a bucket to catch any water left in the hoses. Pull the drain hose from the appliance drain hose or utility sink.
Why won’t my washer drain and spin?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
Why won’t my Maytag washer drain and spin?
A top load Maytag washer not draining may have a defective lid switch assembly. On top-loading washers, draining and spinning will only occur if the lid is properly closed and activates the switch. Try depressing the lid switch with your finger to see if the machine drains and spins.
Does Maytag Bravos have a filter?
All modern Maytag washers have filters that should be regularly cleaned every 3-6 months to prevent harmful lint buildup or clogs. In top-loading machines the filters are in the center of the agitator tube. They can be removed by taking off the agitator cap and pulling the filter upward.
Does Maytag Bravos have a lint filter?
1 Answer. Hi, There is no mention of a lint filter, in the owner manual. However there is a drain pump filter, part #14 Basket and tub parts diagram mentioned in the parts list, which is there to trap lint from being pumped out to the drain.
How do you force a washing machine to drain?
If not, follow these steps:
Step 1: Turn off the power and lay down towels. For safety, unplug the machine. Step 2: Locate the drain hose at the back of the washing machine. Step 3: Drain the water. Step 1: Turn off the power and lay down towels. Step 2: Locate the drain hose. Step 3: Drain the water. Step 4: Scrub the filter.
Why is there standing water in my washing machine?
Water In Bottom of Washing Machine Drum: Why It Happens
Your lid mechanism is broken or not engaging fully. Your drain or hose is clogged. Your load was too large for a good spin cycle. Your washing machine’s sensors are damaged or old.
