Resetting the XC controller
Press and hold down the , and buttons.Press and release the RESET button in the lower wiring compartment.Release the , and buttons. The display should now show 12:00a. m.All the memory has been cleared and the controller may now be reprogrammed.
How do you reset a sprinkler system?
How to Reset a Sprinkler System
Turn the control dial to the “off” position.Press the “next” button to access the clear-memory feature. Press and hold the “off” button until the display stops blinking.Turn the control dial to the “run” position.Press and hold down the “minus” arrow and “prog” buttons simultaneously.
Why is my Hunter irrigation system not working?
The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain sensor on your sprinkler system? If so, slide your sensor bypass switch into the “BYPASS” position (on an SRC, turn the dial into the RUN (Bypass Sensor position).
Where is the reset button on a Hunter thermostat?
Press the end of the paper clip into the “Reset” pinhole and hold it for two seconds to clear the programming. The location of the hole varies depending on the model, but it is usually located near the bottom or side of the front panel and is clearly marked.
How do I reset my hunter X2 controller?
X2 – Total Reset
Turn the dial to the RUN position. Press and hold the program button.Press and release the RESET button located inside the lower wiring compartment. When the display reads the controller station count; (e.g. 14) then DONE, release the PRG button.
Why does my hunter sprinkler system keep running?
A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. NOTE: In the Start Times dial position, the numbers 1-4 do not represent stations.
How do I know if my sprinkler controller is bad?
Sprinkler System Troubleshooting — 5 Signs Of A Faulty System
Controller Isn’t Working Properly.Low or High Water Pressure.Sprinkler is Stuck or Won’t Come Up.Puddles on Lawn or Around Sprinkler.Uneven Spray Patterns.When to Call a Professional.
How do you troubleshoot a hunter pro c controller?
Solution
Make sure sensor is micro-switch type such as Mini-Clik®. Check that the jumper has been removed from the SEN terminals. Confirm proper operation (see “Testing the Weather Sensor”).Manual Single Station Mode will override the sensor. Use Manual All Station Mode to test sensor.
How do you troubleshoot a hunter thermostat?
Locate the tab at the bottom of the thermostat and press it in to release the front plate. Remove the front plate, and replace the two AA batteries. Replace the faceplate and examine the display. If the display is still not functioning properly, you will need to take a closer look at the thermostat’s wiring.
How do I reset my hunter heater?
To reset the heater: 1. Unplug the heater and wait 10 minutes for the unit to cool down. 2. After the 10 minutes, plug the unit in again and operate normally.
What does a flashing 4 mean on a Hunter thermostat?
4. Indicates if the fan is set to Auto or On modes. 5. Allows you to switch between Heat, Cool, and Off modes.
