How to Program Your Hunter X-Core Sprinkler System
Step 1: Set The Current Time. First, you will want to ensure that the current time is correct. Step 2: Set the Start Times. Next, turn the dial to “Start Times”. Step 3: Set the Run Time. Step 4: Set the Watering Days. Step 5: Test Coverage. Step 6: Finished!
How do I test my Hunter Pro C sprinkler system?
To initiate the test program:
Press and hold the PRG button. The station number will be flashing.Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes. After a 2 second pause, the test program will begin.
How do I start Hunter Pro C in Spring?
Spring Start-Up Checklist
Open the system main water valve slowly to allow pipes to fill with water gradually. Verify the proper operation of each station valve by manually activating all zones from the controller.Walk through each station on the controller, checking for proper operation of the zone.
How do I change programs in Hunter Pro C?
Length:
Start with the dial in the RUN position.Press and hold the button. Turn the dial to the WATER DAYS position.Release the button.Use the and button to change program modes.
Why is my Hunter irrigation system not working?
The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain sensor on your sprinkler system? If so, slide your sensor bypass switch into the “BYPASS” position (on an SRC, turn the dial into the RUN (Bypass Sensor position).
Why does my hunter sprinkler system keep running?
A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. NOTE: In the Start Times dial position, the numbers 1-4 do not represent stations.
How do I reset my irrigation system?
How to Reset a Sprinkler System
Turn the control dial to the “off” position.Press the “next” button to access the clear-memory feature. Press and hold the “off” button until the display stops blinking.Turn the control dial to the “run” position.Press and hold down the “minus” arrow and “prog” buttons simultaneously.
Where is the reset button on a Hunter thermostat?
Press and release the RESET button on the back of the front panel.
How do I turn on my Hunter XC sprinkler system?
X-Core – One Touch Manual Start and Advance
Hold down the arrow (>) button for 2 seconds. This feature automatically defaults to program A. The station number will be flashing. Press the arrow (>) button scroll to the station you wish to begin with.
