Turn the dial to Seasonal Adjust. Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen. Your ESP-Me is now restored to the factory default settings.
Why did my sprinklers stop working?
Your Sprinkler System Is Not Getting Water
If the handle on your backflow valve gets inadvertently shut off, it restricts any water from flowing past the backflow and to the sprinkler system valves. Your rain sensor might be faulty. A wire might have been cut. The timer may be broken.
How do I reset my Rain Bird WiFi module?
Reset the WiFi module. While plugged in, press and hold the button on the WiFi module for 5 seconds. After this reset is complete it will be necessary to set up the WiFi module again in the Rain Bird App as if it was new.
Why does my Rainbird sprinkler system keep running?
A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.
Where is the sprinkler controller located?
Often the valves are located inside one or more in-ground valve boxes. The tops of these boxes will be at ground level, and these, too, are usually fairly easy to spot and access. The valve box, or sometimes the valves themselves, are sometimes buried underground.
Why do sprinklers get stuck?
The most common cause of a stuck sprinkler head is dirt and debris. If dirt, rocks, leaves, or grass gets caught between a sprinkler body and the sprinkler riser, it can clog up the works and stop the riser from sliding back into the body. Resulting in a sprinkler head that won’t go down.
Why won’t my sprinklers turn on manually?
Here are some common reasons why your sprinkler system won’t turn on: Lawn sprinkler control timer isn’t working correctly. Clogged or dirty sprinkler heads. Broken sprinkler heads.
How do you fix a sprinkler that won’t rotate?
How to Do It
Disassemble the sprinkler head. Take off the filter at the bottom of the head. Rinse the filter in a bucket filled with clean water to wash out debris.If this doesn’t work you’ll need to have the sprinkler head replaced. If it does work, make sure the head is properly adjusted when you re-install it.
What is Rainbird controller password?
The controller password is restricted to letters and numbers, 4-8 digits in length. No special characters. If you use a special character it will not be registered in the password. As an example, if you typed in 1234@, the password would be stored as 1234.
Should sprinklers run twice a day?
Usually 1 or 2 times a week is sufficient. If you want to determine the maximum amount of time your sprinklers can be left on at one time, observe a cycle from the beginning to the time when runoff begins. That is the maximum amount of time that you let your sprinklers run in any given watering.
How do I reset my Rainbird ESP tm2?
The current date and time will not be affected.
Turn the dial to Seasonal Adjust.Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen.Turn the dial back to AUTO RUN. Your ESP-Me is now restored to the factory default settings.
