Washer agitator bolt with rubber gasket and thread sealant. Head is 7/16 inches in diameter.
How do you take a Maytag washer apart?
Locate the three screws on the top rear edge of the control panel that secure the control panel to the rear of the washer. Remove the three screws with a Phillips screwdriver. Rotate the control console forward and unhook the tabs on the bottom of the control console from the holes in the top of the washer.
How do you get a stuck agitator out of a Whirlpool washer?
Appliance Tech – Moderator
It’s great for removing stuck agitators. It slides under the agitator then you connect a water line and as it fills with water it expands. If you’re going to cut it off, use a hammer and break off the top part of the agitator to give you better access to the bolt hole.
Can you use a washer without the agitator?
A washer without an agitator tends to use less water and energy. They have a larger capacity because the spindle of the bulky agitator doesn’t take up space. An alternative impeller mechanism that is installed in the middle of the washer basin is effective in cleaning clothes.
