Cutting Translucent Panels
The score-and-break method is time-consuming if the panels are thick, or if you have to cut several of them. It also won’t work for curved cuts. As an alternative, you can use a power saw to cut acrylic plastic sheets.
What tool do you use to cut plastic?
You can use a hacksaw, fine-toothed saw, circular saw, or jigsaw to cut plastic. If you use a hacksaw or circular saw, you’ll also need a plastic cutting blade. Avoid using saws or blades with large teeth because they will chip or break the plastic and create rough edges.
How do you cut plexiglass light covers?
The safest and surest way to cut replacement wraparound fluorescent light covers is to use a hack saw. Set the cover on a flat surface with the open end down, mark the cut line with a pencil and hold the cover securely with one hand while you cut with the other.
What is a plastic cutter?
Logan Acrylic Plastic Cutter 709-1 is a hand held cutting tool for scoring plastic and acrylic sheets. Inexpensive and handy for quick sizing of acrylic for general framing.
How do you remove fluorescent light covers without clips?
Single Fluorescent Bulb Fixtures
If your kitchen is lit by a single fluorescent bulb instead of several, its cover may be held in place with a nut on the side. Use pliers or a wrench to twist this nut counterclockwise. When it comes off all the way, you can slide the bulb cover away from the nut.
How do you remove the plastic cover from a fluorescent light fixture?
To remove an acrylic cover from a fluorescent light fixture, push up on one of the short ends of the cover while supporting the other short end with your other hand. As you push up on one short end, angle that end of the cover up into the light fixture a little bit.
How do you clean plastic fluorescent light covers?
Remove the cover from your light fixture and shake out any dead insects or other loose debris. You can then use denatured alcohol or warm soapy water to wipe the plastic down and remove any dust or dirt.
Can you cut plastic with a hot knife?
A hot knife: Using a hot knife to cut through plastic exposes you to the risk of a nasty burn, or the plastic catching fire. Power tools: Using high RPM (revs per minute) power tools will melt the plastic you are cutting through, running the risk of getting a burn.
How do you cut plastic without cracking it?
Using a Hand Saw
The important thing is to use a fine-toothed blade. You can use a hacksaw, hand jigsaw, or fine-toothed saw. Although it will take some work and muscle power, a hand saw is perhaps the best way to get a clean cut without breaking, snapping, or melting your plastic.
