If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do I reset my Hayward Aqua plus salt?
Turn Salt System Off and On
With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.
How do you reset Aqua Rite control panel?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do I reset my Aqua Trol salt generator?
To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds). Desired Output % Dial 1 to 100% sets the level of cell operation in % of operating time.. Example: 50% (factory default) cell is operating and generating chlorine 50% of the total pump/filter operating time.
How do you reset the logic on a Hayward Pro?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus key once. This should reset the light and message.
How do you calibrate a Goldline salt system?
The calibration screen will start counting down from a higher salt reading than what the actual level in the pool water is. Once you see your salinity level, push the switch up to “super chlorinate” and then immediately back down to the “Auto” position. It is now calibrated.
How do I unlock my Hayward Pool remote?
Unlock Configuration Menu To unlock the Configuration Menu, repeatedly press the Menu button until “Configuration Menu” is shown in the Menu Display. Press and hold the Menu Display for 5 seconds. Refer to your pool control’s manual to determine what options are offered within the Configuration Menu.
What does chlorinator off no cell power mean?
No Cell Power’ means the current chlorinator cycle has been interrupted due to no voltage being detected when the cell power relay was turned on. Page 4. Turn off power to the controller.
Why is my salt generator not working?
The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.
How do I reset my Pentair salt Cell?
Press and hold the “More” button for 3 seconds to enter system status mode. All the lights will scroll across the panel, and then go dark. Only the “Power”, “Cell”, “Life”, and “Low” lights will be lit.
Why is my salt cell light blinking?
If the “Inspect Cell” light flashes by itself it is an early indication that the salt generator needs a manual reset. Each cell is equipped with 500 operational hours and requires a manual reset once it expires. To reset the cell, hold down the “Diagnostic” button for 3-5 seconds.
