If the subfloor is concrete, you may need to glue the threshold down. To do this apply a strong adhesive to the edge of the wood flooring, and then place the threshold over the gap between the two sections of floor and push down on the piece to glue down.
What kind of glue do you use for a threshold?
I’d say a bit of Liquid Nails (use whatever type is spec’ed for wood) and some brads would be your best bet. I would use Gorilla Glue, as polyurethane glues are waterproof in a way that polyvinyl acetate glues aren’t.
Can you glue transition strips to concrete?
Apply a 1/4-inch-wide line of construction adhesive to the bottom of the transition strip where it will rest on the concrete.
How do you secure a floor threshold?
To install a wood threshold onto wood or carpeted floors:
Pre-drill pilot holes into the threshold.Position the threshold underneath the doorstops. Nail the threshold to the floor with collated flooring nails.Alternatively, countersink the threshold and fasten it with countersunk wood screws.
Can you glue a transition strip?
Two-part epoxy adhesives are great for a strong bond to a variety of surfaces. Hot melt adhesives and urethane adhesives are also commonly used for transition installations. The molding should be in full contact with the adhesive.
Can you glue metal to concrete?
The best epoxy for metal is Loctite Epoxy Metal/Concrete, a two-part system consisting of an epoxy resin and a hardener. The resin and hardener are combined to create a durable, high-strength bond that dries in minutes and can be used for repairing, filling, and rebuilding all metal and concrete surfaces.
How do you seal a concrete threshold?
Attach New Threshold to Floor: Screw the new threshold to the floor. If the floor is concrete, use a carbide tipped masonry bit to drill holes for either masonry screws or plastic anchors. Install Rubber Seal: Cut the rubber seal to length with a utility knife, and insert it into the grooves in the threshold.
