Once the gas has had time to dissipate, turn the knob to “Pilot.” Then, hold down the “Reset” button and bring the flame of a long lighter close to the pilot light opening. This should light the furnace pilot light. Once you are sure the pilot light is on, release your pressure on the reset button.
How do I reset my propane heater?
An Alternative Way For Restarting The Furnace
Turn off the gas valves of the furnace to prevent the flow of propane.Turn on the burner now.Let the burner burn for a couple of minutes to let the residual gas from the valves and airflow out.Now open the gas valves of the furnace slowly and restart the furnace again.
How do you fix a pilot light on a gas heater?
How to Fix Your Pilot Light
Find your gas valve. You need to turn the valve to the off position for at least three minutes.Once you have had the valve at off for a few minutes, switch it over to pilot setting.You will need a match that is lit. Set the pilot valve to the on position.
Why does my Dyna Glo heater won’t stay lit?
When a propane heater won’t stay lit, often what is happening is that the propane heater may sense that the flame is defective in some way, triggering the propane heater’s safety functions and causing it to shut off. The problem may be a genuine defect or it could be an issue with the sensor.
Why won’t the pilot stay lit on my wall heater?
The Pilot Won’t Stay Lit
A pilot that won’t stay lit could be the result of a blockage in the pilot tube. Turn off the gas, clear the tube with compressed air, and relight the pilot. If that doesn’t work, you may need to call a repairman to come and install a new thermocouple.
How do you light a gas heater with electronic pilot?
If you have a gas furnace, here are the steps on how to light a pilot light.
First, locate the pilot valve on the furnace. Find the gas valve and turn it to the “off” position. Turn the valve to the “pilot” position.Press and hold the reset button.If the reset button fails, ignite the lighter.
Why would pilot light go out?
Improper Venting & Airflow
Sometimes a pilot light can go out as a result of some source of wind or air simply blowing it out. If this happens, there could be an issue with how your flue pipe is set up or how your system is venting.
How do you reset an automatic pilot light?
Press the gas control knob down all the way and hold it in the depressed position. If you have no igniter, move the match or barbecue lighter flame to the end of the pilot tube; the pilot flame should light immediately.
Why won’t my pilot light stay lit on my propane heater?
When your propane heater’s pilot light doesn’t stay lit, it’s most likely because of a dirty thermocouple, a dirty pilot, and a clogged orifice. The heater will also fail to work, in case it is placed in a windy area – a wind barrier will get the problem solved.
